Not sure if I’m posting this in the right place or not, but here goes….
I am in the process of building a G4 Xserve as a home project. I have a logic board, PSU, and a drive interconnect board so far, I plan on buying the rest of the internal essentials from Apple before long, but it will have to go in a custom built enclosure, since Apple want alot of money for a case.
This extends to the drive modules too. I am led to believe that the small amount of wiring at the end of a drive module is just a straightforward pin mapping from an IDE connector (and molex power plug) to an SCA-80 hot swap connector. This strikes me as easy enough to build myself, but I was wondering if anyon can help me out with the which pin goes to which part. I don’t have any modules to check with. I’m guessing someone who reads this is bound to have one somewhere……?
.
.
Comments are closed