Home › Forums › Older Versions of Mac OS X and iOS › Mac OS X Server 10.3 › General Discussion › Panther 10.3.2 server & VPN config

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 8, 2004 at 3:14 am #357368
    cpendleton
    Participant

    Another newbie post here, but after much effort I finally have DNS working internally as well as DHCP. Next is VPN and I’m at a stumbling block:
    I setup VPN for L2TP, not pptp with what seems like resonable information (group, IPsec shared secred, ip range), and enabled some inbound ports on my Netgear FR114P router that I found at another site (UDP on ports 500 & 4500; IP on 50).
    Whenever I try and start VPN, it starts Panther’s firewall and only starts VPN for a slit second.
    I tried enabling L2TP on Panther’s firewall thinking that it too needs to run and it listed a completely different port (something like 1701?). Firewall starts okay but VPN again just flashes on momentarily.

    1) Thoughts?
    2) Any step-by-step out there that I can use or leverage?

    Best,
    Charlie-

    February 22, 2004 at 3:03 am #357449
    cpendleton
    Participant

    Joel,

    Long story short. I ended up re-installing server and now the VPN service seems to launch okay. Specifically though, what ports do I need to allow inbound on my Firewall? Not that it should matter but I am using a Netgear FR114P.

    Best,
    Charlie-

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed

Copyright © 2025 AFP548. All Rights Reserved.